 STEINEL's
The HG3002LCD has been discontinued. See
the HG2310 for replacement This
page is left for existing owners of the tools.
New Electronic Hot Air Gun
with the Newest State of the Art Hot Air Gun Technology. See other Steinel
Hot Air Guns
- Continuously variable temperature
- Continuous LCD temperature output indication
- Continuously variable air flow
- Cool-air Stage
- Use as a bottom heater to melt Chip Quik
Alloy for Low Temperature SMD Removal. Use in conjunction with stand
(Part #01450) and 3 inch reflector Nozzle (Part #07301) for PCB
Bottom Heater. See Chip Quik
instructions for use as Warm Air Bath for SMD Removal.
Click here for more specifications
Click here for Director and Reflector Nozzles
for use with all Steinel Hot Air Guns.
Please Click on different parts of the image for information about the
respective image spot
| Technical Specifications |
UL CSA Listed |
| Voltage: |
120VAC |
Temperature Display: |
LCD Continuous Display |
| Output: |
1500 Watts |
Blowers: |
Continuously Adjustable |
| Temperature: |
Stage 1: 120º F |
Air Flow: |
Min. 7 cfm, Max 17.6 cfm |
|
Stage 2: 120º F - 1100º F |
Weight: |
31 oz |
| Measured at 5 mm in front of the ejector tube |
Noise: |
<70db (A) |
Temperature Control: The Continuously Variable Temperature
Control adjusts from 120ºF to 1100ºF just by turning the large knob on the
rear of the gun and reading the temperature on top at the LCD panel.
Off - On Switch: With the switch flipped down the unit is off. The first
click up is cool air only, for simply blowing cool air for cleaning or cooling
down the gun and the job that you were working on. The second click is for hot
air with continuously variable temperature by the control on the rear of the gun
and continuously variable air flow by a control at the trigger portion of the
gun.
Speed Control: This is a control that you roll with your index finger
which controls the speed of the motor blowing the air. The minimum air flow is 7
cfm and the maximum is 17.6 cfm.
Output Nozzle: This is the nozzle which has several
adaptor nozzles
available for deflecting and directing the air flow.
LCD Display: The LCD Display includes a bar graph as well as a numerical
display. When you first turn the temperature knob, the display reads out the
preset temperature. Then after a couple of seconds it reads the actual
temperature of the nozzle as measured 5 mm from the nozzle.
|
