CapWizSavr Installation Instructions
CapWizSavr $25.00
2. Disconnect the battery connector.
3. Remove the four screws holding down the printed circuit board.
4. Unsolder the test lead connections and remove the solder from the holes.
5. Unsolder and replace the two 1-ohm resistors (Figure 1) with the 0.82 ohm resistors provided with the CapWizSavr.
Click Figure 1 to enlarge
7. Solder the leads from the CapWizSavr to the Capacitor Wizard inserting the leads from the circuit side and soldering on the component side (Figure 2).
8. Reinstall the Capacitor Wizard printed circuit board using the four screws removed in step 3.
9. Remove the two pieces of tape backing from the CapWizSavr and press the CapWizSavr onto the inside of the back cover below the battery pack if possible. If it will not fit below the battery pack, position it above (Figure 3) making sure to leave room for the battery connector.
Click Figure 2 to enlarge
11. Route the test leads through the small groove in the box of the Capacitor Wizard.
12. Reinstall the back cover using the screws removed in step 1.
You can now use the Capacitor Wizard normally. It will withstand up to 400VDC on charged capacitors or even live circuits. However, we do not recommend that you test circuits with power applied.
ALWAYS REMOVE THE POWER FROM ANY CIRCUIT BEING TESTED - Your Capacitor Wizard is protected but YOU ARE NOT!
Click Figure 3 to enlarge
Order the CapWizSavr for
$25.00
