|
CapWizSavr
Installation Instructions |
|
Printer Friendly Page |
|
To install your
CapWizSavr follow these instructions exactly.
CapWizSavr
$25.00
 |
1. Remove the four screws from the
back of the Capacitor Wizard and remove the back cover.
2. Disconnect the battery connector.
3. Remove the four screws holding down the printed circuit board.
4. Unsolder the test lead connections and remove the solder from
the holes.
5. Unsolder and replace the two 1-ohm resistors (Figure 1) with
the 0.82 ohm resistors provided with the CapWizSavr. |
Click Figure 1 to enlarge |
|
6. Solder the test leads to the
CapWizSavr (Figure 2).
7. Solder the leads from the CapWizSavr to the Capacitor
Wizard inserting the leads from the circuit side and soldering on the
component side (Figure 2).
8. Reinstall the Capacitor Wizard printed circuit board using the
four screws removed in step 3.
9. Remove the two pieces of tape backing from the
CapWizSavr and press the CapWizSavr onto the inside of the back cover
below the battery pack if possible. If it will not fit below the battery
pack, position it above (Figure 3) making sure to
leave room for the battery connector. |
Click Figure 2 to enlarge |
|
10. Reconnect the battery connector.
11. Route the test leads through the small groove in the box of
the Capacitor Wizard.
12. Reinstall the back cover using the screws removed in step 1.
You can now use the Capacitor Wizard normally. It will withstand up to
400VDC on charged capacitors or even live circuits. However, we do not
recommend that you test circuits with power applied.ALWAYS REMOVE
THE POWER FROM ANY CIRCUIT BEING TESTED - Your Capacitor Wizard is
protected but YOU ARE NOT! |
Click Figure 3 to enlarge |
|
Buy a Capacitor Wizard with a
CapWizSavr
installed for $229.00
|
