Please Click on different parts of the image for information about the respective image spot.

Order for 5% Discount | Home Page | Professional Tool Page | Back to SC7000Z Specifications | Free Trial

• TRIGGER:  The ergonomically correct trigger is very easy to pull and the Desoldering Tool has very little vibration when running.  
• FILTER:  The filter cartridge is disposable, but can be used a very long time because solder builds up in a mound on a baffle in the middle of the filter. Air flow is around the baffle and into the high fibrous cotton filter. The filter only catches solder dust and flux fumes. When the filter gets dirty about one-half of the way through, then dispose of it and replace with a new filter and cartridge. There is also a secondary filter which must be replaced at the same time. There are five filters and five secondary filters to a package. The part number is 70-08-00. 
• VACUUM PUMP:  The pump is a diaphragm type generating very high vacuum (typically 650mmHg). Since there is a very short distance from the pump to the tip, full vacuum can be realized very quick (typically 0.1 Sec.).
• TEMPERATURE CONTROL:  The temperature range of the unit is from 350 degrees C. to 550 degrees C. It uses Zero Crossover Type Feed Back to keep the temperature constant. There is a chart molded into the side of the handle to convert centigrade to Fahrenheit.
• POWER SWITCH:  There is a Rocker Type Power Switch to turn the unit on and off, without having to disconnect the power cord, located on the bottom of the handle.
• CLEANING PIN:  There is a cleaning pin set that comes with the unit and also a cleaning pin that stores in the handle for quick tip cleaning when your set is not available.
• POWER CORD:  The unit comes in 110V and 220V models. We stock both.
• LONG LASTING TIPS:  The unit comes with a standard 1.0mm tip which is good for about 90% of your desoldering jobs. Six other tips are also available for specialized desoldering. Also a hot air tip is available for blowing hot-air from the tool for surface mount extraction, heating parts for troubleshooting intermittent temperature problems, and shrinking heat shrink tubing.
• TIP HOLDER & CERAMIC HEATER ELEMENT:  The long lasting ceramic heater is very easily replaceable by the user. It simply plugs into the main PC board. A Phillips screwdriver is all that is needed.
• MECHANICAL SWITCH: The switch is used to switch from desoldering to hot-air. By carefully tuning the switch, the volume of air flow can be adjusted for SMD work. An SMD Kit is available for blowing hot-air. The SMD Kit consists of a Hot-Air Tip, a clean filter for blowing, and a wire holder and shim blade holder to assist in removing SMDs.
• FILTER RELEASE:  Pull this tab towards the rear of the unit to release the filter for cleaning or replacement. The secondary filter is behind the primary filter and is accessible when the primary filter is out.
• HANDLE:  The handle contains carbon and the tip is grounded for complete ESD Protection. The complete unit weighs less than a pound.

For more information on the DEN-ON SC-7000Z Desoldering Tool, please call toll free (U.S.A. and Canada) 1-800-394-1984, International 01-316-321-2800. If you would like a free trial on the unit, please read the terms and fill out the on-line form. Thank you.

Back to SC-7000Z Picture

Order for 5% Discount | Home Page | Professional Tool Page | Back to SC7000Z Specifications | Free Trial