|
CapWizSavr
Installation Instructions
|
|
|
To install your CapWizSavr follow
these instructions exactly.
CapWizSavr $25.00
|
1. Remove the
four screws from the back of the Capacitor
Wizard and remove the back cover.
2.
Disconnect the battery connector.
3.
Remove the four screws holding down the printed
circuit board.
4. Unsolder the test
lead connections and remove the solder from the
holes.
5. Unsolder and replace the two
1-ohm resistors (Figure 1) with the 0.82 ohm
resistors provided with the CapWizSavr. |
Click Figure 1 to enlarge
|
|
6. Solder the
test leads to the CapWizSavr (Figure 2).
7. Solder the leads from the
CapWizSavr to the Capacitor Wizard inserting the
leads from the circuit side and soldering on the
component side (Figure 2).
8.
Reinstall the Capacitor Wizard printed circuit
board using the four screws removed in step 3.
9. Remove the two pieces of tape
backing from the CapWizSavr and press the
CapWizSavr onto the inside of the back cover
below the battery pack if possible. If it will
not fit below the battery pack, position it
above (Figure 3) making
sure to leave room for the battery connector. |
Click Figure 2 to enlarge
|
|
10. Reconnect
the battery connector.
11. Route the
test leads through the small groove in the box
of the Capacitor Wizard.
12. Reinstall
the back cover using the screws removed in step
1.
You can now use the Capacitor Wizard
normally. It will withstand up to 400VDC on
charged capacitors or even live circuits.
However, we do not recommend that you test
circuits with power applied.
ALWAYS REMOVE THE POWER FROM ANY CIRCUIT
BEING TESTED - Your Capacitor Wizard is
protected but YOU ARE NOT!
|
Click Figure 3 to enlarge
|
|
Order the CapWizSavr for
$25.00
|
